Skip to main content

I have completed building the bench work and track for my O Gauge layout. I am using WI-FI with 2 AIU's,Android tablet to control the trains.Looking at building a display panel to indicate the position of each switch unit(36 Remote Command Control). I have test each switch and they work fine. I would like to display an LED with resistor(Radio Schack unit built into the LED) for the position of each switch.Although the controller that comes with the switch would be fine as displayed in one of the posts I would rather eliminate them and control with the Android(What is WI-FI for?). Any suggestions as to how I can wire to make this happen?

Note: Platform is 12 by 35 and I do not want to run around checking each switch while  all trains are running.

Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×