Skip to main content

My AMC/ARC Gantry Crane is connected to a LCS Ser2 module.  The Gantry Crane works fine with the CAB2 controller, but not via WiFi using the LCS app on an iPad Air 2.  The crane is programmed in to the Legacy base and the LCS app with engine ID 22. I see the red and green lights flash on the WiFi and Ser2 modules when using either the Cab2 or app but the green light flashes on the crane controller with the Cab2 only.  Any suggestions of what to check next?  The Legacy controller and base are on software version 1.54.

Original Post

Replies sorted oldest to newest

Sorry to hijack this thread but I just picked up a used amc/arc gantry crane and everything seems to work fine but I noticed as soon as I plug in the power to the controller, the controller and crane both have an electric hum. My old conventional crane didn't do this so I was wondering if this is normal?  When I say it has a hum, it hums when sitting idle and the hum only goes away if I completely turn off the transformer.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×