Skip to main content

SOOOO  I was starting to paint a brass an O-gauge "South Shore Line" Steeple Cab. I noticed on a painted HO version of the cab there were four 3-sided corner roof lanterns.

My first thought was to buy some cabooses with lanterns and strip those to use. Then I remembered(I'm getting old) that I have a 3D printer. So after looking a a few Caboose lanterns and the HO one,   I created a left and right corner lantern with a support bracket to better fix the lantern to the Steeple Cab roof.

The openings on 3 sides will fit small LEDs with a hole at the bottom for the hook up wire. The basic square size is 1/4" square.

lanturns

Attached is the .STLs

here is how I oriented the prints in the printer.

print lanterns orient

Attachments

Images (2)
  • lanturns
  • print lanterns orient
Files (2)
Last edited by AlanRail
Original Post

Replies sorted oldest to newest

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×