I have been using the standard dremel 1-1/2' discs. Is it better to go with a larger diameter, like 2" or larger for a more square cut? What works best you for?
Original Post
Replies sorted oldest to newest
I use the standard disc. I usually cut the track about .25" away from the final cut with a pair of dykes so I can get a straighter angle on the final cut. I did get some larger discs (from another manufacturer), but have not yet used them.
I cut my GG track about 1/8 to 1/4 inch longer than needed with the cut off wheels (1-1/2 and 2"). The cut will be at an angle, then I make the final cut. That way your dremel will be at the 90 degree angle to the end of the track for the final cut. I then open up the end of the rail where the track pin goes, with a track pin and then pull it out using a pair of pliers.
Use a full new wheel to make the 1st cuts of track. A wheel that is worn down will work to cut the final cuts. You can ware down a wheel to 3/8 to 1/2 inch and it will still cut an individual rail end.
I just found this thread discussing cut off wheels. Thanks for your replies anyway.
https://ogrforum.ogaugerr.com/...-cut-gargraves-track
I used the older standard wheels and they cut fine but break pretty easy if you get off 90% from the cut. Now for most work I used the 2 inch wheels, not because of size but because they are impregnated with fiber glass or something and much much sturdier than the old ones. I have actually used them sideways to to do small grinding jobs. I recommend giving them a try.
