Skip to main content

I have a DB220 that I recently purchased to add a little more power to my layout. I have been unable following the quick start guide to get anything from the track status light on the DB220. There is no power going to the track at all out of either set of pins. The network light is on, and the cable is working. I contacted Digitrax support, and after resetting the DCS50 and confirming that the DB220 is receiving a signal over the network, they recommended that I send it back to them for repair. Knowing how long it takes to get a repair from Digitrax right now I thought I would post here to see if anyone else has any suggestions before I send it back to Digitrax. 

Original Post

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×