Skip to main content

Prior to 6.10, I never experienced this issue. Note: I have two DCS remotes, one is about 15 years old, and the other is new as of last year.

I had version 6.10 loaded into my DCS remotes back in November, and finally got to run some trains last night. For the older remote, whenever I scroll to speed steps with the numerals 2 or 3, i.e., 12, 13, 20-20, 30-39, etc) the readout gives an illegible reading - appears like a fraction but is not discernable. I tried new batteries - same occurrence. The brand new remote yields perfect integers.

Again, I've been using DCS since its inception, and never experienced a readout in any DCS remote like this before. As of last November, with 3.10 software, everything was fine. This seems incredulous.

 

Last edited by Paul Kallus
Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×