Skip to main content

Howdy folks, another eBay train marked C-8, another fun set of (minor) problems

UP AC6000 (6-84852) was delivered,

the front right ditch light LED housing was broken off, the SMD LED looks ok, one wire is still soldered to it, the other fell off, would it be ok stripping the broke wire down a bit, then using something like kapton tape to hold it into place until I can order a proper solder kit and fix it? Also would it be recommended to run a new wire entirely, or just re-use the existing one if it reaches? I'll add photos tomorrow when I get more time showing where it fell off.

Original Post

Replies sorted oldest to newest

Sorry for the extended delay, finally got time to sit down, peel the thing open and take a look at the damage. From what I can see I would only need to shed a bit of insulation and then just heat the pad up with the iron (that I still need to be and definitely haven't procrastinated buying) and stick the wire back on

Here's a photo of it:

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×