Skip to main content

Bought a Lionel SP Consolidation 28036. Suppose to be test run only. Seller bought new , ran once and has let sit for 9 years. I cannot get railsounds.  Tried reset AUX1 + 4 as I read the reset chart. Unit runs and responds to TMCC just no sounds. Were there problems with this unit? I put a battery in but it did not help. I believe that the battery should only be for shut down and conventional operation as that is the case with my other Lionel units. If I need a new board where would I get one? Any ideas?  Thanks

Original Post

Replies sorted oldest to newest

Do you have Bell and Whistle?  Is there a switch for RS/SS?  Volume pot turned down?

Then check to ensure the board is seated properly, the Power SUpply board also.  Is the speaker wire connected?  Those are the items to check.  If the board or power supply board is bad, Lionel has them.  Others may have the power supply board, but Lionel will want an exchange on the RS board I believe.  G

FWIW, I've had several (three I believe) RS boards that were "vintage" and stored for years that I had to reseat the railsounds PLCC chips before the sound would work.  If you decide to do that, visit your local Radio Shack and buy a PLCC chip puller, do NOT try to pry them out with anything else!

 

I wouldn't buy anything until you exhaust basic troubleshooting procedures.

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×