Skip to main content

I have a 20-3293 Proto-2 UP 4-12-2 9000 class engine that adds to the DCS system with engine number only but no engine information.  I have deleted the engine and readded but no change.  I have done a feature reset, factory reset, and a conventional reset using the whistle and bell buttons.  The engine is never been added to a "lash-up".  Any ideas on how to fix the problem????  Thanks Bruce

Original Post

Replies sorted oldest to newest

Bruce,

 

If the soft keys are all MTC, then the problem is most likely due to low DCS signal strength.

 

If the soft keys are as expected, then the board has no engine name in it. This would result if either the original board was replaced or the engine was upgraded to PS2, and whoever put in the board neglected to use the DCS Service Loader Program to give the engine a permeant name.

 

This and a whole lot more is all in MTH’s “The DCS Companion 3rd Edition", available for purchase from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at MTH's web store!

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×