I have 5 MTH engines that have all run well on my current layout.  I've done some "re-tracking" on the layout.  2 engines when power is on come on immediately without being started up.  I have to shut them down via my ipad and restart them to have them operate correctly.  So those two run fine on the layout.  I put 3 other engines on and they are NOT recognized and therefore do not go into the ACTIVE level.  One was working fine yesterday, but not today.  I deleted two engines, so I could add them back to the system, but they do not show up anywhere...."no new engine to add".

Any thoughts?  Never had this problem before.

 

Thx,

Mr. Bill of Spokane

Original Post

Add Reply

Post
The DCS Forum is sponsored by
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×