Hi All. Well I guess it was bound to happen. We have a Christmas train show layout set up at our local mall here in Sedona, AZ, and I am using a spare DCS set that I have not used in about 5 years or so. The TIU is a Rev I3, and was working fine when last used, as best I can recall. Discovered today that Fixed output #1 is zero, nada. Meanwhile Fixed output #2 is working normally.

Any suggestions on the likely suspect(s)? Any help is greatly appreciated. 

Rod

We are never too old to learn something stupid....

Original Post
UPDATE: Thanks for the input all. I popped it open and lo and behold, Fixed 1 fuse was blown. Thanks for that suggestion Chris, never had that happen before. I have no idea when or how it might have blown, but such are the mysteries I guess. Its a good thing it did blow though, or something else might have gone pop! Thanks all, Rod

We are never too old to learn something stupid....

Add Reply

Likes (1)
Post
The DCS Forum is sponsored by
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×