Skip to main content

While enjoying my new (to me) Southern Pacific Trainmaster it was discovered that the caboose was emitting sparks from under the trucks. These sparks were so large that they even extended outside of the truck frames.  It seems something went wrong when the rollers were riveted to the truck.  The shaft that the roller is attached to extends so far up that it bumps the bottom of the metal truck frame, completing the circuit.  Both trucks have the same problem.  For now a bit of electrical tape is doing the job.  The coil spring is very weak and I am not sure what it is supposed to do.  Also, the roller is positioned directly over the rivet holding the assembly together, blocking access to it.  Any ideas for a more permanent fix? 

-Nathan Muenks

  SP 1996SP 1996 truck

Attachments

Images (2)
  • SP 1996
  • SP 1996 truck
Original Post

Replies sorted oldest to newest

Sadly, this looks familiar. The spring creates roller force on the rail, and it is now weak (and perhaps the cause of the much sparking) because at a moment of short circuit, the spring carried the amp load and lit up orange like your kitchen toaster. When it cooled, it had lost much of its temper as seen by the discolored turns of the spring. Both trucks will somehow require spring replacement. Your well designed and applied electrical tape insulator should effectively prevent the short.

Last edited by OddIsHeRU

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×