Well, where is it Mike???  You know, with charging lights?

I guess I'd better finally get started. I waited too long. I need better tooling to handle tiny parts but here goes......

( I may as well build another SD70ACe while I'm at it too)

DSC_1880DSC_1881DSC_1883DSC_1884DSC_1891DSC_1897

" on Sour mash and cheap wine " ??

Why go back to DCC when I have DCS!

Attachments

Photos (6)
Original Post

I have had experience handling several different materials. That helps me work the plastic. I think many people here could do this. It just involves some time and desire. With practice, the models hopefully will get better!

 The nice thing about modern diesels is that all the panels are flat pieces of steel. Getting the angles right on the cabs, takes a bit of practice.

" on Sour mash and cheap wine " ??

Why go back to DCC when I have DCS!

AMCDave posted:

Plastic is my preference for building too.  But no matter the material I enjoy seeing others work. 

My O scale intermodal well car....I hope to build about 10....3 down! 

THRALLWELL2

That looks great! thanks for sharing. I want that in G scale!

" on Sour mash and cheap wine " ??

Why go back to DCC when I have DCS!

OK, raining again and I'm bored. So I did a little bit more. I cut stuff up for the inter cooler thinger.

I made a plate to fit the hole, cut in 2 circles. Then I attached a piece of fine mesh screen. Filed it to fit. 

I made a pair of fans for looks too. I will mount them to a scrap bar of plastic.

DSC_2140

DSC_2138DSC_2139

" on Sour mash and cheap wine " ??

Why go back to DCC when I have DCS!

Attachments

Photos (3)
willygee posted:

Impressive Joe....hope it rains more

Thanks. Now it looks like 80% chance of rain, 80% of the week.

So............ I'm back at it.

It's just the layout stages so be kind.

DSC_2150

Soon I'll figure out where to go next! Lots of screens to make.  & I hate screens!

" on Sour mash and cheap wine " ??

Why go back to DCC when I have DCS!

Attachments

Photos (1)

The drawings I'm using from the article in Model RR mag are missing lines near the front of the GE's cab up top. There's something that the drawing took liberty and doesn't appear to be totally accurate. I found out the hard way and now have to re-cut several pieces a little longer. The cab has plates of metal that end short of the front and the drawing seems to have mixed these with the front edges.

DSC_2173DSC_2174

" on Sour mash and cheap wine " ??

Why go back to DCC when I have DCS!

Attachments

Photos (2)

All I can say for anyone wishing to build these is stay with it! All the angles can drive you stir crazy. I just have to do a little bit at a time, and stay at it as long as I can. I think that the EMD ( Cat ) cab of the SD70ACE was easier. There's a few more angles on the GE cab that are tougher to nail down exactly.

DSC_2175DSC_2176

" on Sour mash and cheap wine " ??

Why go back to DCC when I have DCS!

Attachments

Photos (2)

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×