Skip to main content

Opening/Qualifying statement: Fastrack is LOUD.  This is not a post on how to make Fastrack quieter.

My question is has anyone setup a Gargraves floor layout?

Fastrack is not preferred this year due to noise.  Or at least loud enough that we don't run the Christmas train as much as we'd like, since we've hardwood floors.  I've put that 1/2 inch thick, cotton white batting, fake snow, under the track to try to eliminate the reverberation, but it's still ridiculously loud.  Also, it makes it difficult to clean up the dog hair, resulting in a LOT of hair caught up in the working of the PE1225

Has anyone built a gargraves floor layout? I was thinking about just putting down a gargraves loop/circle.

Thoughts? Other than fastrack is not loud. When the wife says it is, it is...

 

Last edited by Nuc Tuber
Original Post

Replies sorted oldest to newest

geysergazer posted:

Try running the train slower. The slower it runs the quieter it'll be.

I've not done it but it might be worth the experiment: that medium-density interlocking 2'X2' exercise matting might help.

I did use the exercise mats on my floor layout.  The noise, in my opinion, is inherent to the fastrack itself. Of course my floor setup has 3 trains running so noise is expected. It’s about 10x16 lots of fun for the grandkids

Attachments

Videos (1)
A78A0A3B-1140-4804-A6B3-AC7CB6CA3065

Hi NUC TUBER,

Yes, Fastrak is loud. I normally run Atlas O track for my Xmas layout. Over the years I ran one 1 loop of track, sometimes 2. Now with Grandkids, more is better, & by the way, noise doesn't usually affect them. I never run on bare wood floors, too noisy. 3 years ago I ran the outer loop with Atlas, the inner loop with Fastrack on a carpet. Still, the Fastrack was almost twice as noisy. I'm not knocking Fastrack, its a nice system, easy to set up & looks nice. If you're having guests over for the holidays & you want to run the trains, you do want the noise level as low as possible so people can enjoy & hear each others conversations. Running slow is a partial solution, but with O gauge trains, track with plastic roadbed is inherent to high noise levels if just used out of the box.

Do you have carpeting in any room for a test? Lay the track there & listen for an improvement. In over 30 years & at least a dozen different Christmas layouts, running any track system on a dense carpet will cut down the noise level considerably. The exercise mats look like a good solution, & would be perfect if covered with white felt available at most craft stores at 72" width to the length you need.

Like I said, I've had many Xmas layouts. The most elaborate was only 5x8 but so heavy it stayed up in our living room till the following Xmas! After the second Xmas, off to the dump.

I've attached an image of last years layout & this years is the same. I believe its 80"x65". The carpet cost $160 because I needed to purchase 12'x6' minimum. Even though the color is "Snow White", its still noticeably grayer than the felt surrounding the tree stand & for me not the perfect solution. The best part is, I roll it up & store it in the attic. It's 3 to 4 times more expensive than the exercise mats & felt though.

I think the spray foam idea could work since it fills that echo chamber roadbed. I'm going to experiment with the floor mats & felt after the holidays. The mats are much lighter & cheaper than the carpet & store easier with the felt, & may be the best solution of all.

I certainly will be interested in your solution.

Joe

Attachments

Images (1)
  • Xmas Layout

The FasTrack is too loud. 

I didn't start in time for this season, but, I will be doing the same for the Christmas floor loop next year. I am going to take the time to cut plywood sections track width in the shape of the loop, use Midwest Cork and Gargraves or Ross. 

Then, I can store small sections of the track layout on ply and quickly set them up on the floor. These can go top of the white felt that I put down on the hardwood floor.

You may be able to quickly substitute tubular (042 in place of FasTrack O36) on cork for this season and use mini binder clips or cable ties to keep the joints tight. Got a train store that is near you?

A piece of gray rubber backed indoor/outdoor carpet under the whole tree/ layout area would cut about 15 db off of the FasTrack noise, but, it would still be irritating - just a band aid idea for this close to the day.

Attachments

Images (1)
  • O42_and_O36

I set up a floor layout with Gargraves/Ross track but it was on a MDF/ Plywood base.  My reasoning behind the decision was to pre make the layout at work and set it up on Christmas Eve. Since the layout was the perimeter of living rm it was a fair amount of work but worked out well. 

I had a dowel at each joint in the plywood. The track then spanned the plywood joint. A screw on each side of the joint in the track ties held the joint together. I did not use flex track at joints.  Tracks screwed down minimally, generally 2 screws per pc. 

45ADC4E3-26EC-4A55-BAA7-0264643109FE

I did the same thing for a standard gauge layout, but used knock down furniture  couplers at each joint. 

Link to that post 

https://ogrforum.ogaugerr.com/...tandard-gauge-layout

149E1B3E-6791-4FB8-B0AB-1652BC9990B7

Attachments

Images (2)
  • 45ADC4E3-26EC-4A55-BAA7-0264643109FE
  • 149E1B3E-6791-4FB8-B0AB-1652BC9990B7
Last edited by wmcwood

Add Reply

Post
The Track Planning and Layout Design Forum is sponsored by

AN OGR FORUM CHARTER SPONSOR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×