The mailman just dropped off my transfer table that I purchased from a seller on Evilbay. I purchased this to replace a post-war transfer table I presently own. It is brand new. I hooked it all up as per the instructions for conventional operation. The table moves as it should. However, the locomotive will not move when I press the appropriate button on the controller. The light on the controller and the one on top of the hut will not light. The accessory controller was pre-wired from the factory. Although it's very difficult to see, the orange wire is connected to the clip under the bundle of wires held in place with a zip tie. This orange wire goes to any power terminal on the transformer. I ran a wire from the "U" terminal on my 1033 to the base of the transfer table to provide a ground.
Any suggestions would be greatly appreciated.
