Skip to main content

I bought two O60 switches without controllers and would like to test them before investing in another controller(Lionel says unavailable). One was for parts or repair and the other is supposed to work. They were cheap enough so I could use them as manual, but would like to know if the one could be used with a controller. I'm trying to avoid taking one off the layout just to test. Does anyone have a procedure to check them out?

Original Post

Replies sorted oldest to newest

On the bottom of the switch there are three terminals labeled Thru, Out, and Gnd.  Just use a wire to short the connections on the bottom of the switch to simulate a controller...the Thru to Gnd and then the Out to Gnd to test the two options.

I would post a schematic of the controller, but this site is not allowing me to do so at the moment. 

Is the circuitry for the controller inputs common to that used by the non-derailing feature?  It's been a long time since I had the back off of one, so I don't remember if the wires are joined together or not.

I'm not sure if it is or not, but as a start, you could just check the non-derailing feature using the insulated rails on each leg.  Power up the track and use an alligator clip or a piece of rolling stock to check if the non-derailing will trigger the mechanism.

-Dave

Last edited by Dave45681

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×