On the frog end of my switches I will install an insulator for the green and yellow wire to enable anti-derail. The green and yellow are also connected to the DCS AIU. I am going to solder a green and yellow wire to terminal connectors. I was going to solder 2 wires to each connector to allow me a wire to use for the track signals. Terry at Custom recommended I do it separately because of a surge hazard being fed to his board. I drew a sketch of what I have in mind to allow 2 separate places to be insulated.. Question, does this look like it will work. Appreciate any comments. 
Attachments
Images (1)
Original Post
