Skip to main content

Replies sorted oldest to newest

There is just two prongs on the board one for each coupler the other two wires need to goto a ground. I have the engine and have done it. if you want to just plug in you need one wire from each coupler to goto the board two spots. To me the easiest way was to cut one free about 2" above the jack and connect a wire from the other coupler. then take the other wire from each coupler twist together and fasten to your ground on the frame. 

This was before they did separate prongs for. just looked at your link and it is basically what I'm saying 

By the way this was how Boxcar Bill told me to do it as I just bought two coil couplerss from his as it was cheaper than the kit. 

Last edited by rtraincollector

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×