Skip to main content

I have 2 Atlas O Alco units (C424 &RS1) equipped with TMCC.  Had both for years and every time I bring them out the 1st 5-10 minutes of running they jump around, have flickering headlights and lose sound - all signs of poor TMCC signal I have summized?  More bizzare is that after this initail bad behaviour they run normal no issues after say 10 minutes running (that on any real railroad would have ripped the train apart many times over).  I thought dirty track but cleaning did not improve this and its only these units, the rest of the fleet runs without issue. Any ideas what is going on here?? Thanks, Doug

Original Post

Replies sorted oldest to newest

Thanks Richie, that certainly is a good place to start and can only help. I have cleaned the wheels before and this may have improved signal reception a bit (if in fact that is the issue?) I guess I will find out after I leave them on display for a bit and try to run in future.  I hesitate to open them up as no idea what to look for?  In any event I can live with it, just so odd and only these engines seem to have the issue (I own about 15 TMCC locos), and they have done this every time they sit for say a month.....

I’d make sure the pickup rollers are clean, not only their surfaces that touch the rail, but especially their roller axles since these are older locos. If you have any track cleaning fluid., a drop on both axle ends should do. I usually spin the rollers at high speed with my Dremel tool to more thoroughly clean the axles.

Many TMCC locomotives that have been around for ten to twenty years have developed a bit of oxidation on connector pins.  The simple fix is to reseat all the boards and connectors.  If it's only sound, the older RailSounds board through Railsounds 5.5 had two PLCC chips in sockets, it's very common for those pins to develop oxidation and have a poor contact.  Using a PLCC extraction tool, you can just slide them out a bit and reseat them, job done.

Hi GRJ,

You have been right too many times for me to not give your explanations a credible foundation.  However, if there was oxidation on the board connectors or dirt on the rolls or track, that would be more of a consistent issue.  However, Doug (DMBX) states the issues are eliminated after a period of time.  This in my mind would be a component temperature issue.  I do firmly believe that the suggested remedies suggested by you and others should be acted on as they are easy remedies if they are the cause of the issues experienced by Doug (DMBX).  My $.02

Well, swapping boards will accomplish what I suggested, reseating the connections!   However, it's even easier to do what I suggest, no new boards need to be in the picture.  I've seen lots of engines over the years that exhibit temperature sensitivity, and a majority (but clearly not all) the time it was simply poor connections.  Remember, as the engine warms up, things expand, including connectors and their pins.

I have seen a number of temperature sensitive components cause similar issues as well, and I didn't dismiss your observations, just added another possibility.

Thanks guys I appreciate all your thoughts. I think I will just give the units a good cleaning and live with it for now....I mean letting the locos warm up before a show (when they are allowed again?) is not such a big deal.  Despite the occassional issues I must say most of the fleet have been reliable performers.  I guess just like the real deal - motive power issues can happen😉

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×