I recently purchased the K line Milw Rd F7 AA. When i try to run it, as soon as power is applied to the track it trips the breaker after about 5-10 sec.. I opened it up and it looks like the 150 Ohm resistors might be fried on the DCRU (see picture). It's difficult to get a good pic, but, the brown discoloration goes down the side as well as on the top on the right side resistor and just slightly browned on the top of the left resistor. Since I bought this used, I have no idea of what would have caused the resistor(s) to fry. Should I just replace the resistors or should I try to source another DCRU (MDK-090 Rev D, Ver 4)? I am worried that there may be other problems with this DCRU and my thought was to replace it, however, it appears that these boards are not readily available. If anyone has one these and wouldn't mind parting with it, please contact through my email or ph#. Also, does any one know of a good place to get a 150 Ohm, 3W, 5% resistors? I am hoping to find the same resistors as shown in the picture. Any other suggestions on what the problem might be, please let me know.
Thanks
Norm
