Hi! New to the forum so here goes! I recently purchased a NS flame paint scheme C44-9 Bluetooth equipped. I am running it via a lion chief universal remote. It was smoking fine for a while but then stopped. I can hear the fan running but no smoke. Think I may have overloaded it with fluid. Any ideas?
Engine item number? Does the air coming out feel warm? Have had friends come over with this issue, just ran them for a while. Last resort disassemble, turn over on a towel or something to empty smoke unit. Hesitate to suggest turning it over as fluid may leak internally.
Air feels warm. Got it upside down right now
How much smoke fluid did you put in it? those Lionel Legacy smoke units can take a pretty good amount of fluid. IMHO 20 drops is nothing and I tend to put at least 30 to prime in mine.
On a new dry smoke unit, I put at least 30 drops into it, sometimes more. If you're feeling heat, and you're sure you have enough fluid, just run it for a spell and you'll most likely get smoke.
I'm guessing I've probably put about 35-40 drops total
In that case, stop putting fluid into it and run it until it cooks some off and starts smoking.
We got smoke now! Thanks for the tips!