Skip to main content

hi just got my first legacy loco and programmed ok ran for a while and went through shut down for the night, the next day went to run it and as soon as i added track power the engine started and all the controls had no effect had to shut down and reprogram then it worked am i doing something wrong? its a lionel gp35 1933401

Original Post

Replies sorted oldest to newest

The Legacy command base channel ONLY pertains to the CAB2 to base communication, it doesn't change the track signal at all.  Obviously, if you don't have the command base and remote on the same channel, it won't work, but the remote will also be sitting there telling you it can't find the command base.

When you issue commands on the CAB2 keypad, or control buttons, does the LED on the command base flash?  If so, the command base is alive and well and talking to the CAB2.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×