Skip to main content

Took my k-4 out to run today from being boxed up for some time now. Cleaned all the pick ups then went to program it. As soon as I switched over to run and fired it up, its throwing a code. Three flashes, so went to run it a little to see what was wrong. Engine goes over my first joint and sound cuts out. Also smoke isnt working as well but the whistle effect is. Im not to fond of opening it up, been some time since I working on this stuff. Is this a common problem or is there a easy fix.

Original Post

Replies sorted oldest to newest

Common issue, that vintage of Legacy locomotives had the run of bad fan motors.  Be a bit careful opening it up, there are several small connectors right up front that are fairly easy to pull the wires out of if you don't pry them out of the socket, do NOT pull on wires to remove connectors!  I carefully work them out of the socket with a very small jeweler's screwdriver.

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×