I'm learning how to operate my Legacy remote but in the process I did something that I don't know how to fix.

Both cab and base version 1.60.

Issue: I somehow placed "22" where the ENG icon is showing E22 on the bottom and 1 on top. Then pressing the button it shows 22 on top and beneath that it shows E1. The same concept follows the other buttons with different numbers i.e. RTE is R0 in small with 11 on top and R11 is small with 0 on top.

I have a couple videos that shows my issue.

I have 2 Legacy locomotives. I have done the clear database via remote and no change. I also used the grey button on the back upper right of remote and no change.

What I want done: remove the E22, R11, R0 and start fresh like you just bought the system. Am I missing somthing? What do I do?

Thank you in advance, Nathan

 

Attachments

Videos (2)
20190908_163149
20190908_164802
Original Post

There is nothing to fix.  The larger number is the current select, the lower smaller number is the previous selection.  When you double punch the button it switches between the 2.

Marty

 

Below the Signature...

"You should have bought a train."

 

A couple of other things to think about...

You should avoid assigning a Legacy / TMCC engine, using the RUN/PGM procedure located in the engine manual, address 1 and address 99.  

Address 1 is what the engines ship as and adress 99 is an "ALL" function in Legacy.  

 

Marty

 

Below the Signature...

"You should have bought a train."

 

Add Reply

Likes (0)
Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×