All diesel directional lighting on PS-1 was 1.5V and usually a double bulb.  I have them in stock, but need to know the length of the wiring so it is an easier install.  Though I will say you may have some issues getting bulb out of plastic lens.  G

MTH Authorized Service Center

Authorized ERR Dealer

Lionel Independent Repair Tech

Virginia Train Collectors Member

Uh... not all George, we've had this conversation before.  Some of the products had lighting boards that took the 1.5V headlight from the PS/1 board and switched 6V bulbs.  I did specify if they're direct connect they'd be 1.5V bulbs.

Attachments

Photos (1)

Since it is bad you can try pulling out but don't be surprised if it breaks.  Factory sometime used glue to hold in.  Use a small punch to push plastic lens out of shell, use drill bit by hand to cleanout residual glass.  G

MTH Authorized Service Center

Authorized ERR Dealer

Lionel Independent Repair Tech

Virginia Train Collectors Member

Add Reply

Likes (1)
Post
This forum is sponsored by MTH Electric Trains
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×