Skip to main content

When I disconnected the eunit from the  1688e motor I didn't take pictures to remember the way it was wired.  In looking at a typical wiring diagram, the blue and yellow wire of the eunit are attached to the brushes.  The green is attached to the motor field and the pick up wire from the roller or slider is connected to the eunit drum.  However on the 1688 motor there is only solder point  for one of the brushes, but there are two places on the motor field that had wires soldered to it.  What am I missing?
Thanks for any assistance!

Attachments

Images (3)
  • motor 1
  • motor 2
  • motor 3
Original Post

Replies sorted oldest to newest

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×