Lionel 6-18010 PRR S2 turbine travel direction problem

Try doing an engine reset with your cab1 or legacy system.  Instructions are in your manual. If you dont have either I am not sure what to do

Unless he's added it, this is not a TMCC unit.  It's from around 1992, I believe.

-Dave

Dave45681 posted:

Unless he's added it, this is not a TMCC unit.  It's from around 1992, I believe.

-Dave

1991. I’m running it as though it is a conventional engine.

There were two problems, 1) the wire, that determines whether or not the engine’s direction can be reversed, was not inserted properly in the socket. 2) the display track doesn’t seem to be able to reliably reverse the engine’s direction. After getting the reversal unit wire securely installed, I was able to run the engine on a 12 x 12 oval, reversing it several times. Back on the display track, it reverted to the same problems.

@George Mason posted:

1991. I’m running it as though it is a conventional engine.

@Dave45681 posted:

Unless he's added it, this is not a TMCC unit.  It's from around 1992, I believe.

-Dave

Does anyone have the instructions for positioning the jumper in the engine cab?