Skip to main content

I currently have the Lionel Fire Car that needs a bulb replacement.   The revised instructions says I need the 10-8411-530 bulb as a replacement which is listed as a 6 volt bulb.  My grandson and I run the train at about 10 -12 volts thus the bulbs life is shortened.   My question is can I get away with using a 257-300 blinker which is a 14 volt bulb?  I don't car if it blinks dimmer I just don't want to melt the foam insert that holds the bulb in or melt down the red plastic dome if we go with the 6 volt replacement and run it at a higher voltage.

Thanks

Original Post

Replies sorted oldest to newest

The 257 (Lionel number 2307-300) is the correct bulb for that car. 14.volts. My guess as to why they revised the bulb to 6 volts is the newer fire car motor vs. the original 52 is the motor draws less voltage to run and the 257 bulb requires a lot of current to make the flasher in the bulb work. So Lionel put the next available flasher bulb--6 volts--- as a replacement. It works, but flickers and blinks rapidly and is annoying. As a side note, I have a 257 bulb in my 8379 PRR fire car and it works great.

Last edited by Chuck Sartor

I am not aware of a #257 LED equivalent bulb that is actually a viable replacement for the #257. The #257 has an integrated flasher and none of the LED replacements that I am aware of have an integrated flasher - they are simply generic G4 1/4 Ba9s LED filament bulbs incorrectly marketed as replacements for the #257. Sure, you can build/procure and install your own flasher circuit, but a pack of 10 bulbs from the auto parts store should be more than sufficient and probably more economically sound.

Add Reply

Post
This forum is sponsored by Lionel, LLC
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×