Skip to main content

Good morning to all...

 I have a new skeleton log car that is broken and I'd like to know how people are repairing die-cast cars.  This is a 6-19497 Westside Lumber skeleton lumber car and one of the 4 cross-bar members broke off where it meets the main I-bar car body.  This cross-bar is the attachment point for the hold-down chain that holds the log on so the repair must be stout in nature AND very permanent!  My thoughts go to JB-weld, Gorilla Glue, Tech-Bond (replacement for the old 'Cool-Chem' found at www.Tech-Bond.net) and then perhaps drill-tap and screw once the glue had set for 24 hours.

Thanks in advance for any assistance!

Best,

Dave

Original Post
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×