Hello, 

today I ventured to the garage to use two SP AA shark noses. I found that the rear was having trouble firing it’s coupler.  So I tried to reprogram the set of shark noses only to find no sound or movement from the powered unit. (Note) I tried numerous ways programming them and found that the coupler finally fired, but it does not matter since the powered unit will not roll or make any sound what so ever. In p.s. conventional mode it ran fine. any advice helps👍🏻
-RJ

 

Original Post

I sometimes have had the same thing happen. By pushing the AUX 2 button on the Trainmaster Control hand held if that is what you use it resets the locomotive's features. If you use the Legacy Command hand held there should be a similar button to press.

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×