Skip to main content

Replies sorted oldest to newest

Tach reader issue that could be a bad harness connection, partially broken internal tether wire.  Loose 7 pin connector on board, dirty tach tape, too large a gap on the tach reader, tach reader becoming faulty, broken solder joint on engine side PCB that tether plugs into.  Does this occur on curves mostly?  If so tether or PCB most likely culprits. G

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×