Skip to main content

Replies sorted oldest to newest

Not sure yet. Did you get the blinking lights when you pressed in the program button? Hook the track wire from the base to the U terminal on the A handle. Legacy base on first, then ZW, then try the manual mode set. Hook the track wire from the base to the U terminal on the A handle.

There is a calibration procedure in the manual for the handles. It cautions that it should not be needed, but I did it anyway when I purchased one of these pre-owned. It was an early 1.2 version that had the 1.3 modules sent with it by the previous owner.

That's worth a try.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×