Skip to main content

Recently, I have gotten another MTH DCS remote, due to the old one's scrolling wheel finally breaking beyond repair after around 15 years. Using the new remote, programming all of my engines went fine and I am able to run each engine individually. The problem arises when I try to use the remote to create lashups. Once I create a lashup and select it to start up, the remote says the engines are not on track and can't be found. However, this only occurs when the engines are in lashups, as all the engines work perfectly when running only one. Any help on what to do would be greatly appreciated!

Original Post

Add Reply

Post
The DCS Forum is sponsored by
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×