MTH Motor Mount Needed

I thought I had one but use dit long ago to power a dummy Atlas GP9.

I wonder if the ones from a dummy Williams E7 would work?  I have 2 trucks plus the mounts from powering that too.

What’s it going in?..I might have some....

Pat

Bob, I don’t know if the Williams mounts will work. They’re all pretty similar but I’m finding the depth to be slightly off. Well, on a few Lionel’s that is. Can you provide a few pics of the trucks please?

Pat, I’m putting it in an MTH centipede. One was substituted with an unknown manufacturer mount when I bought this project. They’re clearly different heights. I have another centipede that I compared the 2 mounts to. One is identical, one is not. From what I see on MTH’s website, they’re used in 2 & 3 axle diesel trucks. 

If you can get me some measurements and we can converse on measured values, I might have one....you can message me off-line, or post it up here, and others might can help the two of us sort it out...up to you..

Pat

Pat, sorry for the delay. I got 8 stitches in my right pointer finger so I wasn’t doing any train work for the last week. But I was able to measure the motor mount.

•large dia. flange (motor face side): 1.255” dia X  .138” high

•next step: .825” dia X .257” high

•last step (inserted furthest into truck): .610” dia X .277” high

•square boss protruding from the side: .200” wide X .257” high. Protrudes .076” past the large dia flange.

Take a look and let me know what you find. I appreciate the help!

Ok, lemme check and see,....you need this to fit in a centipede, correct?

Pat

Pat,

Yes. MTH uses the same motor mount in all of the 3 axle power trucks. 

Pat,

Looks like I was able to locate one on eBay. Thanks for helping tho!

Dan