Skip to main content

This was a very early P5 with 5volt board that I upgraded to PS3.  It has the cast shell, 2 motors with one motor driving the one axle with traction tires.  The second motor drives the other two axles.

now heres the issues:  when running in conventional on my test track it wont go into neutral or change directions.   I figure its locked in reverse but since i cant get it into neutral, I cant reset it.  It runs fine in command control, no problems at all, using the remote or my iPone 10.

second issue: when running in command and going over a bit of uneven track, it stops but the traction tire axle keeps spinning and the other two don't move at all!!  Its getting power and it doesn't short out.  I don't understand why the one motor doesn't also  keep turning.  I am aware of tracking issues with this engine and i have managed to ‘fix’ the uneven track with shims, at least most of them.  Any ideas would be helpful.

Both motors do work, i checked it on its side powering the pickups individually with both a z750 and a Lionel 1033.

thanks

Original Post

Replies sorted oldest to newest

Try this for the 1st issue.  Start the engine up in conventional, as soon as you hear the startup sequence, do the 1 horn, 5 bells to reset the engine.  This needs to be done quickly to catch the engine before is has a chance to move.  You should hear the 2 horn blasts for confirmation.  Then try and see if you can change directions.  It might take a few tries to get the timing right.

Thanks for help, seems i got it reset for conventional running, N,F,N,R.  Not sure how that happened but it works.  

2nd issue:  i still don't understand why just the motor with the traction tires is turning while the other has stopped.  I always thought both motors run at the same time.  It is definitely caused by uneven track and not the fault of the engine.  It just takes light downward pressure on the engine to make it go again.  This may be where removing the spring in the front truck will help as previously suggested.

also i am not going to remove the shell to check for the tach reader, because of risking pinching a wire.  Under DCS it runs great except for this one issue which is mostly a track problem on my carpet central.  
Thanks again

Dave,

As Ron said above; Only one motor has a speed sensor on it.  The board does not recognize that one wheel set is slipping or not moving.  It sends the same DC pulse to both motors based on the information it is receiving from the tach reader.  There is a physical condition allowing one set to move while the other is binding up.  (your uneven track, a switch, curve too tight, even smoke fluid or oil on the wheels will cause this)

Last edited by David Minarik

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×