Skip to main content

2 replies

MTH Premier Line Conrail Bicentennial Diesel having trouble moving and MTH power source breaker keeps tripping after reset.

Bob DixeyBob DixeyOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

Today I was running my Conrail Bicentennial diesel and it was running fine for a little while and I noticed that it had stopped even though I did not press anything on my remote to stop it. I shut it down and restarted it and started up fine but would not move when I moved the dial on my DCS remote. I did give it a push and it then took off at high speed. Also the power source I use from the Z750 transformer which is used to power up the DCS system keeps tripping even after I press the button to reset it. I have had the power source from my Z750 for 18 years and I would like to know if it is time to replace it and could that be what is causing problems with this locomotive?

Original Post

Replies sorted oldest to newest

G GGGOGR Forum Member

Try a different engine, if it works fine the transformer is not the issue, the engine has a motion system problem.  Is one of the motors binding? Dirty, traction tire off?  Could be a bad motor, poor or loose solder connection to motor.  Tripping breaker means an over load of some sort so you need to figure this out, before more damage done to engine.  G 

Add Reply

Views: 158
Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×