Skip to main content

Replies sorted oldest to newest

@BOB WALKER posted:

That MTH DCC manual recommendation from Engineer Joe was right on. The list of CV's in the manual looks a lot like the CV list with SoundTraxx. Setting the BlueRail APP to Tsunami2 would probably be a good start in the initial setup.

I'm gonna play with it this weekend.  When I hit the "Short Bell" button, the engine shuts down.  I also need to figure out how to shut off the smoke.

Thanks Again!

Ron

I wonder if you can move the F functions so they do what your remote says? The smoke info posted below is from Ray's site about a PS3 one gauge diesel:

Smoke (if Equipped) F12 – Smoke On/Off. Enabling F12 will turn the smoke unit on. Disabling F12 will turn your smoke unit off. F13 – Smoke Volume. There are three smoke volume levels in your MTH PS3.0- equipped engine – Low/Med/High. The default for this is set to High. You can adjust the smoke output (amount of smoke the generator puts out) by pressing the F13 button twice. This sets the level to the next step. For example, if you are currently at the High smoke output level, pressing F13 twice (toggling it on then off) will set the smoke volume to Low. Pressing F13 twice again will set it to medium

Ron, what's the exact model number of your engine?

What are you using for control exactly?

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×