Skip to main content

Replies sorted oldest to newest

Well I looked on e-bay again and this popped up. I swear I have looked on here a dozen times with no luck. I ordered 2.  MTH MOTOR MOUNT FOR ANY RAILKING ARTICULATED SERVICE CENTER REPLACEMENT PART | eBay                                                                                                                                            Thanks for the help

Rick

Since this cast part is not available, I would consider the possibility of making this a steel fabricated part. I would check with a local machine shop if they can make this as a fabrication and the cost to make it, if the cost is individually prohibitive I would contact the other Forum members who are seeking this part and maybe you can pool this order. The material cost to fabricate one or more assemblies should be minimum, the drafting time to make the fabrication drawing and direct shop labor are a sunk cost for one or more fabrications, i.e., the more you order the unit cost will decrease. The machine shop will need the zinc rot part for reference to cost estimate the fabrication.

Last edited by John Ochab

I did get them. I got them in last weekend and they work great. It looks like the old one's swelled up and got too tight and would not articulate and broke. It was almost like they soaked up the oil and became brittle and swelled up. Anyway got it all back together only to find the control board is bad. Tried resetting it but not much luck. I think we are going to convert it to tmcc. Plan on getting my son Matt the Legacy controller for his birthday anyway.

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×