Skip to main content

I have a fairly new GP38 that I did a factory engine reset on using the iPad app. Now, my DCS app will not find the engine. It finds all my others, but not this one. Maybe there's a procedure I should have followed?? I had it powered up on the track when I did it. It still runs if I switch to a track with conventional power but the DCS will no longer bring it up. Did I smoke something??

Thanks! Bob

Original Post

Replies sorted oldest to newest

Did you check signal Strength with that engine when it was in the remote?  Can be poor ground terminal, bad pickup continuity on one truck.  May have DCS/DCC switch issue, can have wire harness interference over the board.  Caps need to lay horizontal not vertical.  Search can get you info with pictures.  G

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×