Skip to main content

I have a fairly new GP38 that I did a factory engine reset on using the iPad app. Now, my DCS app will not find the engine. It finds all my others, but not this one. Maybe there's a procedure I should have followed?? I had it powered up on the track when I did it. It still runs if I switch to a track with conventional power but the DCS will no longer bring it up. Did I smoke something??

Thanks! Bob

Original Post

Replies sorted oldest to newest

It's a 20-21229-1. I should add that it would run forward through switches without a problem, but would get stuck it those same switches in reverse. I began by blaming the switches, but my other 3-4 MTH engines don't get stuck. I dismantled the trucks and cleaned everything well, only to have the problem continue. That's why I tried a reset. Hope that helps!

Add Reply

Post
This forum is sponsored by MTH Electric Trains
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×