Skip to main content

Replies sorted oldest to newest

PURCHASED IN 2002 NEW PREMIER TRIPLEX INSTALLED BCR FEW YEARS AGO USING 180 BRICK THRU TIU JUST  WILL NOT POWER UP EITHER WITH THE TIU OR CONVENTIONALLY SMALL CLICK COMING FROM TENDER WHEN POWER IS APPLIED NO SOUNDS OR LIGHTS-DO KNOW IF IT IS THE BOARD OR THE BCR-NEVER HAD A BCR GO BAD AND WHEN THE BOARD IS DEFECTIVE THERE IS USUALLY SOUND OR LIGHTS BUT NO MOVEMENT


Tom , I had a couple PS2 steamer's tethers that were OK but I found the board in the engine that the tether plugs into had  bad solder connections.   I resoldered the wires and everything was good.   Might be worth a look. 🤔

The wires at that board are packed together tightly and I think the motor turning back and forth might have pulled on a couple wires after some time.     

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×