Skip to main content

Replies sorted oldest to newest

Today I found out the accessory plugs on the Z4000 is only rated to 4 amps,  Apparently I didn't read the manual carefully enough when I got it.  I have had it for about 4 years.  I use the 14 volt output for all my ross switches, lights and some few accessories..  Over that last week I have finally installed the balance of all the accessories I had.  After installing a few more today the breaker flipped, was not even running any trains.  Then I see 4 amp printed on the  breaker button.  Had to switch 14 volt accessory line to my KW.  

To me is just seems low to limit it to only 4 amps.

 

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×