Skip to main content

The other day while running my layout one of my two old ZWs that I use for accessories was getting to the border of being hot! I have not had a chance to start looking for problems, and I wonder if anyone out there might suggest what to start looking for. Is it possible that I could have developed a problem within the one ZW like a short between the terminal posts, as I use all four posts. As warm as the transformer had gotten, there was no circuit breaker that tripped, So far I am stumped, but need to start looking at possibilities in a day or two.  Thanks,

Original Post

Replies sorted oldest to newest

Transformers under load do run hot. Lionel transformers are about 80% efficient, which means the other 20% comes off as heat. A 275 watt transformer Could give off about 60 watts of heat. I recommend that circuit breakers be added to each of the output terminals so you do not have to worry about overloads or short circuits that the transformer’s own circuit breaker does not catch. It would not hurt to take the cover off and just take a good look around inside of it. 

I hadn't seen anyone comment on this but it also applies to time at load, so if you are loading it up heavy and then ran for a long time it may heat up more than you were used to.  If it is all of a sudden heating up more and ALL detail on loading etc are the same as before, yo may have an issue.  If it's heated enough to damage the winding's I think you would know pretty quickly but smell or magic smoke escaping.  You also need to consider what others are alluding to, review your actual Watt loading and then determine if you are with in reason or if you may be actually over loading the ZW. Anything over about 180W constant would probably be considered an overload situation. does not matter if it is only accessory lights either.

Lastly, if you have bad connections on your track or dirty connections, that will affect conductivity, which will increase your current draw as well.

Due to some other tasks, I haven't been able to start looking at my problem. I will say this. Both ZWs are used for lights and accessories. Therefore not all accessories are operating at the same time. In fact during this problem of a hot top to the case, I wasn't operating any accessories. I may have had my 64 bulbs worth of flood lights on as a demonstration, but again, all these things are being split up between two ZWs , thus 8 voltage posts.

Old ZWs often run hot without the breaker tripping, which is not good. The breaker often goes out of calibration, especially as they age. I've seen some that will never trip no matter how hot they get! A new breaker is required to restore proper function. Get a solid state breaker.

As other have stated  above, check your amp draw. At best, you should be pulling no more than 12 amps at 18v. That's TOTAL for the transformer!

 

Chris

LVHR

How "hot" is it getting? Warm to the touch or is the big "L" medallion on the top of the case burning you? I use a Postwar ZW (with added TVS diodes and fast blow fuses) to power my DCS/TMCC layout. After an hour of running two trains (Lionel twin AC motored F3 pulling 3 dummy units and 7 passenger cars with incandescent bulbs, & a MTH Premier 2-10-4 Texas with a 9434 Pittman motor, smoke on, pulling 12 scale SFRD refrigerator cars and a lighted caboose) the top of the case where the "L" medallion is located is warmer than body temp. IR gun says it's about 108*. Won't burn you but it feels warm.  

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×