Skip to main content

My PS 2 MTH RK R36 is stuck in neutral in conventional mode. When I start the train you hear the station announcement or you hear a long horn blast. Hit the directional button all you get is the station announcement, when you press horn or bell , nothing. Tried the 1 horn, 5 bells, nada. I also run this train with DCS Explorer and I have no issues. Tried the reset using the app, no help. I thought it was the battery but you would hear the engine sounds for about five seconds after the shutdown.

Original Post

Replies sorted oldest to newest

This morning I started the train and it acted normal. After no more than 3 min the train started to pick up speed on it's own so I pulled the throttle back to zero. When I tried to start it up again it was stuck in neutral. I don't have any regular 9v, I'll get some later so I used a fully charged rechargeable and it's still stuck in neutral.

If the train is at rest for over a hour or two it works fine when you start it up for only a few minutes. Then, horn blast , station announcements and then it's stuck in neutral. Bell and horn buttons don't work and if you press direction the lights change for direction and you hear station sounds. All this while being stuck in neutral. I'm hoping it's just the battery.

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×