Skip to main content

Hi all,

I’m trying to program this set into my legacy remote but the engines do not respond when I do the normal program procedure of entering the ID, pressing AUX1, and then set. Am I missing something? Thanks in advance. Note that these engines are just TMCC and not Legacy.

Max

Original Post

Replies sorted oldest to newest

Max,

Do you have a Cab-1 TMCC remote? I think it's easier to reset them using the Cab-1 than the Cab-2. If you don't have a manual, here's the link:

https://www.lionelsupport.com/...file=72-4534-250.pdf

Page 29 goes through the function restore procedure. This will likely fix most hangups with programming. It's very important to follow all the power up/down steps. Be sure also to put the remote in TMCC mode. You should be able to enter the locomotive info into the Cab-2 and "prepare" it to accept the engines once they're reset. Hope this gets you in the right direction. Those are gorgeous engines BTW .

Wendell 

Last edited by CSX Indy

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×