Skip to main content

I am using DCC in a #1 gauge engine that had a board with synthesized sounds that sounded terrible. I have a bunch of Lionel Railsounds 4 boards (don't recall where I got them) and built an interface between the DCC control board and the Railsounds board for whistle, bell etc as those codes are listed. What I'm looking for is the digital code for the chuff. 

Original Post

Replies sorted oldest to newest

While waiting for a reply I went ahead and applied power to an R2LC. According to my old notebook notes pin 17 which I have as an I/O input that the axle switch is attached to. I applied a ground to pin 17 and got an AUX 1-9 command which is the smoke on code. Don't know if this will cause the sound board to do a chuff as I ran out of time for further investigation. 

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×