Skip to main content

I bought an additional new TIU.  It has the latest firmware 6.10.  The fixed channel 1 works fine.  However, fixed channel 2 puts out no DCS Signal.  Any engine starts up automatically and I have no control with DCS remote in shutting it down engine, etc.  The same happens when putting the variable channels 1 & 2 in fixed mode.  I have reset the TIU to factory defaults.  I tried reloading the TIU's firmware but same thing happens with no DCS Singnal on fixed channel 2, variable channels 1 & 2 in fixed mode.  Is there anything else I can try doing before sending the TIU to MTH for repair? 

Thanks

Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×