Skip to main content

Two of 11 command switches failed to take commands nor will they take an ID# reprogramming attempts.  All the switches have been working fine for months until this morning.  I've cut the power, then tried again.  One switch blinks when the program key is depressed, but will not take an ID set command. The other one just stares at me. Both work with the manual control.  Is the command function kaput, or is their something I can do to wake them up?  Of course both switches are dead in the middle of my 7x16 layout...so,  I've not pulled them yet.   Thought I'd ask for help first.  Thanks,

 

Original Post

Replies sorted oldest to newest

I had the same problem with mine.  turned out the program button  was shorting to the metal plate under it.  if you take the bottom plate off and it works fine you will know that was the problem.  just bend the plate out of the way.  you are the 3rd person I no of to have this same problem and it was the same in all 3 cases.

good luck 

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×