This engine has been sitting on the shelf for several months.  I attempted to start it up and I get "engine not on track",  I deleted engine and tried to add back as suggested and get "no engine to add".  Tried to recover engine with no luck "cannot find engine".

The engine does have a BCR which I waited a couple of minutes to make sure it was charged.  Any thoughts?  Could the BCR be bad?

 

 

Original Post

It sounds more like the old 5 volt board has failed. You may have to replace with a proto 3/2 replacement. But for the cost and depending on how well you like this model of engine, a replacement can probably be found on Ebay.

It does run conventionally, everything works.  How do I do those recommended  resets when the engine is not in my DCS remote?

Last edited by JDA

Thanks for all the help.  Finally solved problem.  Turned out it was a track wiring issue which I am still tracking down.

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×