Skip to main content

Not a problem with my several other Command Control Fastack switches, but this 036 does not start blinking when I hold down the programming button.  I'm pretty sure this is a new, first-time-to-use switch. 

Switch works perfectly with remote and manually. No binding, no smoke. Anti-derail works perfectly. 

Any ideas?

Original Post

Replies sorted oldest to newest

Thank you Richie for jumping in to help.

I wish it were something like a pinched or loose wire. Unfortunately, the program switch functions perfectly. Checking continuity on the switch, it works perfectly. I can measure continuity between what looks like a ground up to J1 on the small circuit board and make and break that with the button.

The brown antenna wire makes a gentle loop across most of the left side of the switch and does not appear damaged, pinched or poorly soldered to the ANT point on the board. I wouldn't think the antenna would prevent the switch from going into program mode, but what do I know.

I'm afraid this is one to send back for warranty as it is new.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×